Page 1 of 1
Error message
Posted: Fri Jul 15, 2005 11:20 am
by Pam
If I want to compact the database I get the following message:
"Problem with compacting: Class not registered".
I use XP Pro/Office XP Pro, compacting in Access is no problem. Still, the unregistered class points, to my opinion, to a database prblem, rather than the set up of my system.
Pam
Posted: Fri Jul 15, 2005 11:41 am
by jiri
It is most likely caused by damaged MDAC/Jet installation, you can try to reinstall them (checkout readme file if you aren't sure where to find them), it could help.
Jiri
Posted: Fri Jul 15, 2005 12:21 pm
by Pam
, two questions:
1 MM is most unlikely the only user of this MDA/Jet. So how can I check if MDA/Jet is the problem (which apllications))?
2 On MicroSoft Downloads are 19 updates, where do I find the correct new installation?
Pam
Posted: Wed Jul 20, 2005 4:14 pm
by jiri
1. Due to the message I can say quite for sure that it's problem in MDAC/Jet installation.
2. Try to install the very latest versions of both.
Jiri
MDCA 2.7 SP1
Posted: Fri Jul 22, 2005 1:46 pm
by Pam
Have installed MDAC 2.7 SP1 Refresh. But problem is the same. Go and find Jet now. But again, question: is your analys of the problem consistent with the fact that Access (Office XP Pro, legal version) compresses MM- mbd file without probs, nor does MM has a problem with this, new, MM-mbd. Nor does conversion to Access 97 or Access 2002 effect any of MM's operations.
Kind regards,
Pam
Posted: Wed Jul 27, 2005 2:37 am
by jiri
Definitely install the latest MS Jet, I think it could help. The fact that MS Access works well isn't directly related to this, I suppose no other non-MS application would work well on your machine until the problem is resolved.
Jiri