Page 1 of 1
Position changes when switching from MMdb to Ipod and back
Posted: Thu Jan 17, 2013 12:53 pm
by JohanJooste
Another question - After I've sync an album to my IPod and browsed the IPod to confirm the transfer, I go back to the
MM library finding that its at the top of the library again not at the position I was last at before the sync. Any ideas why
that is and if there is a setting to change this ?
Re: Position changes when switching from MMdb to Ipod and ba
Posted: Thu Jan 17, 2013 12:55 pm
by Lowlander
Are you using the Back button?
Re: Position changes when switching from MMdb to Ipod and ba
Posted: Thu Jan 17, 2013 12:59 pm
by JohanJooste
Nope clicking left on the IPod node under the Media tree and when finished I select Music node under the Media tree - not using back buttons at all.
Re: Position changes when switching from MMdb to Ipod and ba
Posted: Thu Jan 17, 2013 1:07 pm
by Lowlander
Only Back/Forward buttons remember item selected position.
Re: Position changes when switching from MMdb to Ipod and ba
Posted: Thu Jan 17, 2013 1:18 pm
by JohanJooste
You got me on this one - where in the MM interface are the forward and back buttons you are referring to ?
Re: Position changes when switching from MMdb to Ipod and ba
Posted: Thu Jan 17, 2013 1:32 pm
by nohitter151
JohanJooste wrote:You got me on this one - where in the MM interface are the forward and back buttons you are referring to ?
The shortcuts toolbar, you might have to enable it at View > toolbars > Shortcut
Re: Position changes when switching from MMdb to Ipod and ba
Posted: Fri Jan 18, 2013 11:45 am
by JohanJooste
@nohittert51 - I blind here as I do not see the shortcuts bar. Should I create one or is it standard config ? i saw the forward and back arrows under
the Tools toolba r and added the but it still does not remeber position....
Re: Position changes when switching from MMdb to Ipod and ba
Posted: Fri Jan 18, 2013 1:18 pm
by Lowlander
Are you using MediaMonkey 4.0.7? Anyway you can create your own toolbar and add the buttons by right clicking on any toolbar and selecting Configure.