Knowledgebase
Using WASAPI output in MediaMonkey
Updated by Pavle Lacarac on Oct 24, 2017

WASAPI is a Windows interface mode that allows an unmodified bitstream to be delivered to a sound device. It can also provide applications with exclusive access to audio devices, bypassing effects (e.g. system mixer) provided by the audio driver.

Before configuring WASAPI mode in MediaMonkey, you should install the appropriate audio drivers for your DAC and verify that the drivers are working. Usually, there aren't any special settings or options in the drivers necessary to allow them to support WASAPI mode.


To configure WASAPI Mode in Media Monkey 4, run MediaMonkey and:

  1. Under the Tools menu, go to Options.
  2. Under the Player category pick Output Plug-ins.
  3. Click the radio button next to MediaMonkey WASAPI output

The MediaMonkey player will now play sound via the WASAPI driver.

If there are problems with the sound (e.g. clicks) you can tweak WASAPI settings to your liking or set it to use specific supported modes. For example:

  • If you hear static whenever you use a DSP plugin or tag tracks, try enabling Exclusive mode. This mode has options for:
    • A specific format based on your audio hardware
    • Automatic choice of format (per track) - asks the card for supported modes and chooses the one that's closest (best) for the source format of the track
    • Format of the original track - in case of driver problems, this mode won't query the card and starts playback in the track's original format. If that fails, it attempts to query the card.
  • Some devices don't support event driven mode. Disable event driven mode and use push mode if you experience clicks between tracks

Configuration options are available via:

  1. Repeat above Steps 1-3
  2. Click Configure.
  3. On the MediaMonkey WASAPI output plugin configure page...
  4. Select Your WASAPI Compatible device as your output device (you may also select Default. Device DAC is configured to be your Windows default output device).
  5. Check the box next to Exclusive Mode..
  6. Under Exclusive Mode select "Automatic choice of format (per track)".
  7. If your device supports PUSH mode but not EVENT mode (like Emotiva DAC)
    1. Click Advanced.
    2. UNCHECK the box next to "Event driven Exclusive mode (recommended)" and "Event driven Shared mode (recommended)".
    3. Click on OK till you go back MediaMonkey main screen and close options.
(1 vote(s))
Helpful
Not helpful

Comments (0)