Burn delay

[rusty]

fyi, this issue has been fixed in the latest 2.5.4 build (available in the beta forum).

-Rusty

[PRGeno]

fyi, this issue has been fixed in the latest 2.5.4 build (available in the beta forum).

-Rusty

Unfortunately that is not the case on my system. I just instaled the beta version and have the same lock up problem.

It's very sad to have to leave the comfort of Media Monkey, to the convoluted world of Helium just to burn a CD.

This used to work fine, if not very elegently, until the new burn engine was installed.

PRGeno

[Bex]

Perhaps you could try to uninstall/reinstall to see if it works...

[PRGeno]

Perhaps you could try to uninstall/reinstall to see if it works...

Bummer,

I just tried reinstalling, and not only didn't it fix the CD Burning problem, but my carefully crafted window layout and column settings were lost.

So no CD burns, and lots of time to get my MM set up back to the way it was.

As I said, Bummer!

[Bex]

Are you sure you installed the latest Beta? Named 2.5.4 RC-1
Which is found here:
http://www.mediamonkey.com/forum/viewto ... 7306#57306

/Bex

[PRGeno]

Are you sure you installed the latest Beta? Named 2.5.4 RC-1
Which is found here:
http://www.mediamonkey.com/forum/viewto ... 7306#57306

/Bex

My mistake, no I had the 969 version.

Before I came back and saw your message, I uninstalled MM again, and went back to 2.5.1 which worked fine.

Then afterwards, I came back here to tell you and saw your message. So I installed the 974 version and tried again, and this also worked.

So, it appears all is well.

Thank you for the unbelieveable support, and thank you for saving me from having to use Helium ever again (yuk!).

PRGeno